Eqvaliser
12-01-2009, 06:01 PM
Made some aluminium cans today, close to the EU standard
except the botton is a little to low. But hay its my design.
Local Release post : Here (http://www.evisystems.org/forums/downloads.php?do=file&id=13)
Remote Relese post : Here (http://forum.daz3d.com/viewtopic.php?t=103890)
Comments and suggestions :training1:none atm.
Enjoy
except the botton is a little to low. But hay its my design.
Local Release post : Here (http://www.evisystems.org/forums/downloads.php?do=file&id=13)
Remote Relese post : Here (http://forum.daz3d.com/viewtopic.php?t=103890)
Comments and suggestions :training1:none atm.
Enjoy